DASYS High Speed Dome Manual de usuario descargar pdf (Pagina 10)

Chapter 4 Installation Guide

1、Take out the bracket and unscrew the power box from the bracket.

2、Thread cables across the bracket and connect them to the circuit board in

the power box.

Install the dome body to the bracket, screw up with 4 ...inner hexagon screws.

If necessary, apply water-proof glue to the joint gap.

3、unscrew the cover with the mark “SET”, set communication protocol and

addresses. Screw up again with care to avoid water.

After the installation of dome body, use two outer hexagon screws to tighten

bracket and power box.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 40 41

Sin comentarios

DASYS High Speed Dome Manual de usuario Pagina 10